Concrete floors in
Lexington
AL
When we quote a floor in Lexington, the slab decides the system. Not the other way around.
Get my free quoteFree quote . No obligation . Fast response
What Lexington usually asks for
That is what Lexington tends to ask for. The full range is on the table regardless. Every system we install is available here, and the right one is chosen from the slab in front of us rather than from a list.
Concrete Resurfacing
Lexington asks about concrete resurfacing often, and farmhouses and rural properties with shop buildings is the reason.
An overlay is a thin layer of polymer modified cement bonded over the slab you already have. Structurally the old concrete keeps doing its job. The overlay gives you a fresh surface to finish.
It is not a fix for a slab that has failed. If sections have dropped or a crack keeps moving with the seasons, that is a subgrade problem and an overlay will mirror it. We say so when we see it.
It gives you a clean canvas for stain or a coating. Far less cost and disruption than tear out and replacement.
More on concrete resurfacing
Polished Concrete
Given farmhouses and rural properties with shop buildings, polished concrete suits a lot of what we see in Lexington.
How the floor ends up looking depends on how deep we go. A light grind leaves the surface close to how it was poured. Going deeper opens the slab and exposes the sand, then the stone, so you get a terrazzo look out of concrete that was already there.
Polishing is mechanical, not a coating. We run diamond tooling across the slab in steps, each one finer than the last, and the gloss comes from the concrete closing up rather than from anything we put on it.
It reflects light, so a dim warehouse or basement gets noticeably brighter without new fixtures. Sweeping and an occasional damp mop is the entire maintenance routine.
More on polished concrete
Epoxy Flooring
In Lexington, epoxy flooring is a frequent answer, largely down to farmhouses and rural properties with shop buildings.
We grind first. Every time. Diamond grinding opens the pores of the concrete so the resin has something to key into, and it takes off whatever sealer, glue, or old coating is in the way.
Cracks and pits get filled with a repair product compatible with what goes over it, because a patch that flexes differently than the coating telegraphs through the finish within a season.
It resists the things that ruin a garage slab: oil, brake fluid, road salt, and hot tire pickup. Seamless means there is no grout line or seam for dirt to collect in.
More on epoxy flooring
Lexington and the floors in it
Lexington is in northern Lauderdale County, inside the 100 miles we work out of Huntsville.
The concrete under Lexington is farmhouses and rural properties with shop buildings, which tells us where to expect sealer, glue or an old coating.
Locally the driver is farmland near the Tennessee line. Floors in those buildings get treated accordingly.
Lexington sits close enough to Florence, Killen, Rogersville that we frequently run them together.
Lexington is known locally for farmland near the Tennessee line, and the buildings that come with it are the ones we end up in.
Where the floor is already coated and failing, the job starts with taking the old system off.
Other towns in Lauderdale County
Everything we install
Polishing
Decorative
Restoration
Safety
The slab underneath
Slabs around Lexington vary more than people expect, even within one neighborhood. Two houses on the same street can have concrete finished completely differently, which changes the prep.
Whatever is on the slab now comes off mechanically before anything new goes down.
We open the slab with diamond tooling so the coating keys in rather than sitting on top.
Sometimes the honest answer is that a slab is not worth coating. If a crack is still moving, if sections have dropped, or if there is water coming up through the concrete with nowhere to go, a coating will fail and take your money with it. We would rather tell you that in Lexington than sell you a floor twice.
We quote the floor first, in person. Once you accept, the install gets booked as a block rather than squeezed between other jobs, because a resin floor cannot be half finished and left overnight. For a Lexington job that usually means we hold consecutive days and give you the dates up front.
Clear the room before we arrive. For a garage that means everything off the floor, including shelving feet and anything mounted low on the wall that we need to cut in behind. We can work around a few heavy items, but the more of the slab that is open, the better the edges come out.
Whatever the room is, the sequence does not change: open the concrete, fix what needs fixing, then put down the system the slab will actually hold.
Do you actually take jobs in Lexington?
We do. Lauderdale County is part of our normal area and Lexington is inside it. The same people who quote it install it.
What kind of work comes out of Lexington?
Typically concrete resurfacing, polished concrete and epoxy flooring. Lexington is farmhouses and rural properties with shop buildings, and that is what drives the pattern.
Do you do commercial work in Lexington?
Yes, and it is a real part of what we do here. With farmland near the Tennessee line locally, there are buildings whose floors have to survive a cleaning routine, not just look right.
How soon could you get to Lexington?
Usually within a few days to look at it. We are often working Florence, Killen in the same stretch, so fitting Lexington into a run is normally straightforward.
Is there a charge to come look at a Lexington floor?
No, not inside our service area, and Lexington is inside it. The visit is how we find out what the floor actually needs.
Can I talk to a previous customer?
Yes. We would rather give you somebody whose floor is like yours than a general list, so tell us what you are planning.
A floor in Lexington?
Get Kortni out to look at it. (205) 238-8111.